Compiled custom kernel mostly following these guidelines.

MatchProduct 'Elo Single Touch Device Input Module'Ī few things I did that I don't think I actually needed to do, but I'll list them here just in case the above fails MatchProduct 'EloTouchSystems,Inc Elo TouchSystems 2216 AccuTouch® USB Touchmonitor Interface' I also just came across another calibration tool called evtest, look in my reference section for a link to a guide on that method The method I used is xinput-calibrator, so that's what I'll put here. One that I've tested and another that I just came across.

Now that the screen is displaying, you may find that you need to calibrate it because the touches are inverted or just way off or whatever. #Adjust hdmi signal level (Can be tweaked if there's interference, default value was 2, default boost was 4, max value is 11) #Set the resolution to 800 x 600 at 75 HZ and allow audio (For a chart of hdmi mode resolutions see, I chose 800 x 600 because I'm using a 15' screen and this makes for bigger touch buttons and the program I'm using fits best on the screen at this res) Code: Select all #Make the screen not go over the edges

No elo touchscreen detected